So, basically, I would have to make longer tie rods? I figured that would be in store. When I make my new spindles, could I keep the steering arms close to stock location to help with the geometry? I'm not running ridiculously small tires on this thing, so ground clearance isn't too big of an issue. I would just really like to keep this steering setup because it is a very quick ratio (not direct steer quick, but quick), and its stout as all h#ll. It's not going to be super low either, I figured about making the frame 3-4" off the ground. It'll never see "off road" either, just driveways and yards at the most.