What have you done to your tractor today?

today I fixed my choke and cleaned my carb.

Well today i extened my hand lever.

well today i fixxed my steering problom with new rubber bushings till i get the $$$ to make a new front axle

got my baby running, the 29 is going on dixie yall

Tractors are all still snug in the truck, but we loaded the tool box on the tool/parts trailer and locked it down, and started gathering tools/supplies/parts for Haspin.

I started working on my side shifter for my rally..so far i have pretty much everything except the linkage that goes to the trans.

Today I ordered $60 worth of parts on ebay and washed her down GOOD!

I sharped up the blades and went to a mowing job with my Hot Rod mower and the coil is acting up again. I guess Ill have to order another one. I was hoping to get the rest of the 2 acres of 5ft tall grass knocked down today so I could have it ready for final cut next week.

Not alot, but just got home from a KISS concert

I got the old craftsman tractor running!

Thunderdivine wrote:

Not alot, but just got home from a KISS concert

I saw them for the "Crazy Nights" tour

We had floor seats

I bet u had a great time

Chopperhed wrote:

Thunderdivine wrote:

Not alot, but just got home from a KISS concert

I saw them for the "Crazy Nights" tour

We had floor seats

I bet u had a great time

Cool, yea We had a blast. and great seats, to bad it never gets dark here now until like midnight so we only jad the bangs but missed the light show.

Thunderdivine wrote:

Chopperhed wrote:

Thunderdivine wrote:

Not alot, but just got home from a KISS concert

I saw them for the "Crazy Nights" tour

We had floor seats

I bet u had a great time

Cool, yea We had a blast. and great seats, to bad it never gets dark here now until like midnight so we only jad the bangs but missed the light show.

Sometimes it sux being that far north, looks like a great show

I have a question for you guys, do you think it is possible to mount a car radio on a tractor without having too mach draw to where it is draining faster than it is being charged?

Thecrazyoldcraftman wrote:

I have a question for you guys, do you think it is possible to mount a car radio on a tractor without having too mach draw to where it is draining faster than it is being charged?

i gotone on my lifted, been using it in the garge for 3 weeks, just had to charge it today, lol, id say u would be ok, but i would have a back up way to start it.

i want to mount one on dixie, but if i do i want a marine one, cause this thing is going to be getting sunk lol

I fried my starter rolled the tractor back on me hill climbing broke a spindle going down a hill. And went on one hell of a ride shootingover a hill in nuetral when my hip bumped the shifter so I tool the ol pony for one hell of a ride lol

so I should probably make an optional pull start like fearlessfront just in case. thank ya'll for the replys!

Today  I slapped a new fuel line on the craftsman and took her for a little run.

Stretch's tractor and Chris's have both had transmissions opened and fixed already... its been a rough Haspin already.

Today, it's only 9:15 but yesterday I put on the basecoat of war machine mk2... and adjusted the fuel mixture. Today I have to upgrade the front pulley and lock the pivot on the front end. I acquired a 6 circuit emergency strobe controller for LED strobes... usually used for emergency vehicle lights but am going to run it on Nightmare for ground effect lights, yesterday I fixed the clutch of a white lt12 I sold to a friend as well

today i put a nice coating of MUD!!!! raw juicy mud. https://www.atltf.com/t2310-mudding-fun#27900
theres pictures at the bottom of that page of todays mudding

today I figured up a new exhaust system for the old craftsman.

not a thing as yet. having a bit of a burnout at the moment

Got the painted rims and new rear 22x11-8s on my craftsman last night! Looking forward to the test drive!

Quote :

haven't been on here for awhile. been since march. been working on the blue mtd got a sexy 17.5 ohv briggs on her, and a put new gas line on it yesterday. try to start her today