kohler command 12.5 problems

Hey guys the spark plug wire in my kohler command is shot, anybody know how to replace just the wire it is connected directly to the magneto, its a long shot but if its possible ill try it.

I have a kohler command 14 hp magneto that im going to put into the 12.5 but I would hate to decommission that motor over the magneto.

as far as i know, you have to replace the coil. you can pick one up fairly cheap

you might be able to do it. i've never pulled one apart before. I know a spark plug wire is universal.

What does the wire look like? I've cut open a new car's plug wire and apperently its grafite something or other inside. Black, feels like a pillow feather, and nothing gets on your hands when you touch it. Never knew about it until i saw it, i was in shock expecting wires.

this one isn't really removable from the looks of it, most plug wires have a snap connector on both the spark plug side and the coil/distributor side, this one looks permanently mated to the coil/magneto.

EDIT: the wire itself is a regular spark plug wire it is just permanently connected to the coil and I want to seperate the two so I can put a new wire on it.

Can you get a photo of the coil? some of them have a seam down the middle of the plastic part you might be able to split?

I can possibly get one tomorrow afternoon after work, but the mower is at my uncles, I am planning to pull the coil off the 14 hp tomorrow and if I get over to my grandmas place Ill take a pic.

im pretty sure you can just cut it and leave some slack and sodder some new sparkplug wire on and wrap it with some electrical tape or use some shrink wrap...... I could be wrong tho

if the coil wire is a metal core then you can repair/replace the wire. although i dont reccomend this for a long term repair,it can be done.check ebay for a coil replacement