- MTD Off-Road Build - Ford LT 110 Off-Road Build - Craftsman GT 6000 Off-Road Build - Sears LT11 Rat Rod Build *2019 Build-Off Winner!*
- Allis B-110 x2, 710 & 716 - Wheel Horse 655, 953 & 500 Special - Case 444 - Bolens Versamatic & 1668 - Cub 106 & 124 - Ford LGT 125 & 145 - White 1650 Yard Boss
Age : 18 Join date : 2016-10-29 Posts : 2946 Forum Rep : 125 Location : Lewisburg, KY
Subject: Re: Redzz02 "Sears Killer" Wheel Horse Mud Mower [2017 Build-Off Entry] [Finalist] Fri Nov 24, 2017 1:29 am
Looks really good, this thing just keeps getting better. Really love the cutout on all the tractors I've seen it done, especially yours. I like how you have it in one unit with the muffler. Keep doing what you're doing man!
Age : 26 Join date : 2010-05-12 Posts : 875 Forum Rep : 50 Location : PA pittsburgh and pymatuning
Years ago this is what the wheel horse was, it was powered by a predator 6.5 with a 5 inch on the motor and 25 inch all terrain atv tires on the rear, it was a hoot to drive and was short of being a monster and would take you anywhere you pointed it to go.
We started off with a rolling chassis two months ago and one week before the finish we have a mower that meets all the guidelines and hopefully can win your votes for first place
Wheel horse b-80 16hp Briggs and Stratton horizontal shaft vtwin 6inch pulley Lifted rear 4 inches to accommodate the larger front tires 3speed hi/lo with 2 inch wheel spacers to kick the rear tires out to match the front 24x9-10 superswamper vampires front and rear. Bumpers front and rear Aluminum belt gaurd Aluminum flywheel cover Led headlights and blue led accent lighting Stainless steel exhaust to the muffler(with a bypass pipe for quiet or loud mode)(selected on the dash) Aluminum fuel cell I build approximately a gallon and half of fuel Rubber diamond tread plate on the footrests Aluminum battery box And a kick ass "camo" style graphics
I present to you my wheel horse mud mower
Age : 46 Join date : 2016-09-06 Posts : 7231 Forum Rep : 543 Location : Central Oklahoma
i still need one more piece of rubber tread plate to cover up my shifter plate and one small piece of door trim edge to go onto the right side foot rest. but other than that the wheel horse is officially done!
i upgraded to a 5/8 belt and with doing that i had to change my engine pulley, it is slightly smaller now. the one that was on it did not have a deep enough V notch to work with a 5/8 belt.
i insalled some exhaust wrap where it was needed and also a stainless exhaust tip.
last but not least i covered part of my dash with rubber tread plate and will be doing my shifter tomorrow.
_______________________________________________ Espyville Mudders White Trash Productions Ohio Offroad Mowers Top Tractor Challenge Host #StopStretchingTractors2021 Builds: Sears Killer, Mud Dynamark, Drift Missile, 4x4 Dynamark + many more